MecLock Safeguards

257 MecLock_Katalog_2025_CAT_2505-10_EN_INT www.strasser-gmbh.com - sales@strasser-gmbh.com Fastening instructions Fastening instructions The following aspects must be observed during fastening: • General: Fastening from the inside of the safeguard to the outside or through the whole safeguard is not allowed. • SFV.D-B01-… – Version FM / FO / FKM / FKO / FMV / FOV / FS21: Fastening is done on the back on M8 threads and with at least 3 screws (from underneath to top) per side profile (two-thirds of the height of the safeguard is fastened at least). • SFV.F – all types: Fastening is done on the back or laterally inside in the profile groove with T-slot nuts (M8) and with at least 3 screws (from underneath to top) per side profile (two-thirds of the height of the safeguard is fastened at least). • SFV.G – all types: Fastening is done on the back or laterally in the profile groove with T-slot nuts (M8) and with at least 3 screws (from underneath to top) per side profile (two-thirds of the height of the safeguard is fastened at least). • SFH.E – all types: Fastening is done on the back or laterally in the profile groove with T-slot nuts (M8) and with at least 3 screws (from underneath to top) per side profile (two-thirds of the height of the safeguard is fas- tened at least). • STV.D – all types: Fastening is done on the back or laterally in the profile groove with T-slot nuts (M8) and with at least 3 screws (from underneath to top) per side profile (two-thirds of the height of the safeguard is fas- tened at least). • All safeguards with stand – type SMxxxx / SOxxxx: The fastening is carried out at the bottom of the stand via the base plates with machine screws M10. In addition, the safeguard must be fastened at about 2/3-height to the side or rear of the machine fence or to the machine in order to ensure the safe position of the safeguard. For any other questions, help and further information relating to installation or fastening of MecLock safeguards please contact Strasser GmbH.