MecLock Safeguards

212 www.strasser-gmbh.com - sales@strasser-gmbh.com MecLock_Katalog_2025_CAT_2505-10_EN_INT Configuration steps Description Configuration steps Description Order code Stroke Freely selectable in millimeters. The tolerance deviation can be ±1 mm. In the case of servo-electrically driven MecLock safeguards, the start position is programmed ex works to be 10 mm smaller than the maximum stroke in the reference position. Hxxxx Clear width Freely selectable in millimeters. The tolerance deviation can be ±2 mm. Tolerances must be taken into account during installation and fastening in order to install the MecLock safeguard without tension. Lxxxx Pane material Panel material PETG: - Good puncture and impact strength - Good scratch resistance - Good chemical resistance - Food safe Polycarbonate: Very good puncture and impact strength Polycarbonate ESD: - Very good puncture and impact strength - The pane has an additional conductive coating Note: Not all components of MecLock safeguards with ESD-compatible panes are always made of ESD-compatible material. Aluminum/Aluminum composite panel: - Opaque - Anodised on both sides Tempered safety glass: - Good puncture and impact strength - Very good chemical resistance - Good temperature resistance Note: The tempered safety glass pane is edged with Ottoseal S70 (1-component silicone sealant based on oxime, neutral cross-linking, MEKO-free). MSxx MBxx Speed Actuator The innovative MecLock system enables high closing speeds to be achieved without overrun. The maximum speed is not limited by the safety system, but by the door leaf mass in relation to the power of the drive and the damping behaviour in the end positions. MecLock safeguards can be electrically or pneumatically driven. Depending on the drive variant, the following maximum speeds are possible: - Pneumatic actuator – control standard (S10): 0.4 m/s (6 bar) - Pneumatic actuator – control quick run (S20): 0.8 m/s (6 bar) - Servo-electric actuator: 1.2 m/s These are the maximum achievable speeds for the individual drive variants. The specific closing times depend on the configuration of the MecLock safeguard and can be found in the closing time diagrams in the technical appendix of this catalogue (see p .231) . MecLock safeguards are supplied ready for installation with all drive variants, in order to minimise commissioning work. P E

RkJQdWJsaXNoZXIy MTIxMzQ=